Keep Mute Configuration; Mute Alert Tone; Mute Alert Tone Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones

Keep Mute Configuration

The following table lists the parameter you can use to enable or disable keep mute.
Parameter features.keep_mute.enable
It configures the keep mute feature.
Description
Note: It works only if "features.allow_mute" is set to 1 (Enabled).
0-The mute feature is automatically deactivated when the active call ends.
Permitted
Values
1-The mute state is kept until you change the mute state manually or the phone restarts.
0 (for other phones)
Default
1 (for CP920/CP925/CP935W)
Parameter features.keep_mute.mode
It configures the mute mode.
Description
Note: The value configured by this parameter takes precedence over that configured by the para-
meter "features.keep_mute.enable".
0-Exit the keep mute state.
1-Enter the keep mute state, but in the idle screen, you can press the mute key to enter or exit the
keep mute state.
2-Enter the permanent mute state, that is, in the idle screen, you cannot press the mute key to exit the
keep mute state. However, during the call, when the call is established, the call is muted by default,
Permitted
you can press the mute key to unmute/mute the call. After the call is finished, it returns to the keep
Values
mute state.
3-Enter the permanent mute state, that is, in the idle screen, you cannot press the mute key to exit the
keep mute state, but during the call, the call is muted by default, you can long press the mute key to
unmute the call, release the mute key to return to the mute state. After the call is finished, it still returns
to the keep mute state.
Default 0
Supported
T57W, T54W, T53W, T53, T53C, T48U, T46U, T43U, T42U, T33P, T33G, T31P, T31G, T31, T30P, T30
Devices

Mute Alert Tone

You can configure the phone to play an audible tone if the mute status of the phone is changed. This allows you to
know if your phone is in the mute or un-mute state. In addition, you can set a periodic reminder which plays the aud-
ible tone periodically when the phone is in the mute state. The time interval must not be less than 3 seconds.
It is only applicable to CP920/CP925/CP935W phones.
Topic

Mute Alert Tone Configuration

Mute Alert Tone Configuration
The following table lists the parameters you can use to configure the mute alert tone feature.
Parameter features.play_mute_tone.enable
Description It enables or disables the phone to play an audible tone when the mute status is changed.
0-Disabled
Permitted
Values
1-Enabled
442
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg