User-Triggered Provisioning Settings Configuration - Yealink SIP-T3 Administrator's Manual

Administrator's Guide for SIP-T2 /T3 /T4 /T5 /CP920 IP Phones
figuration changes) during auto provisioning.
Note: If the phone performs auto provisioning when receiving a SIP NOTIFY message which contains
the header "Event: check-sync", the phone will display the prompt message no matter whether the con-
figuration is updated.
0-Disabled
Permitted
Values
1-Enabled
Default 0
Parameter static.auto_provision.connect.keep_alive
Description It enables or disables the long connection for downloading files via auto provisioning.
Permitted 0-Disabled, the phone uses the short connection for downloading files via auto provisioning
1-Enabled
Values
Default 0
Parameter static.auto_provision.authentication.expired_time
It configures the timeout (in seconds) after which the authentication pop-up box for auto provisioning
Description
disappears.
0-The authentication pop-up box does not disappear from the phone screen automatically.
Permitted
Integer from 10 to 86400 -The authentication pop-up box automatically disappears from the phone
Values
screen after the designated time.
Default 7200
Parameter static.auto_provision.dns_resolv_nretry
It configures the retry times when the phone fails to resolve the access URL of the provisioning server.
Description
Note: For each different DNS server, it works only if "static.auto_provision.dns_resolv_nosys" is set to
1 (Enabled).
Permitted
Integer from 1 to 10
Values
Default 2
Parameter static.auto_provision.dns_resolv_timeout
It configures the timeout (in seconds) for the phone to retry to resolve the access URL of the pro-
visioning server.
Description
Note: For each different DNS server, it works only if "static.auto_provision.dns_resolv_nosys" is set to
1 (Enabled).
Permitted
Integer from 1 to 60
Values
Default 5
[1]
If you change this parameter, the phone will reboot to make the change take effect.

User-Triggered Provisioning Settings Configuration

You can enable the users to trigger phones to perform provisioning by dialing an activation code. This method
works only if there is no registered account on the phone.
The following table lists the parameters you can use to configure settings for user-triggered provisioning.
Parameter static.autoprovision.X.name
94
[1][2]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg