Digit Map For A Specific Line Configuration - Yealink SIP-T3 Administrator's Manual

takes precedence over that configured by this parameter.
0-Disabled
Permitted
1-Enabled, the incoming calls will be forwarded to the desired destination number according to the
Values
string of the digit map.
Default 1
Parameter dialplan.digitmap.apply_to.press_send
It enables or disables the entered number to match the predefined string of the digit map after press-
ing a send key. It is only applicable to the off-hook dialing.
The off-hook dialing includes: pick up the handset, press the Speakerphone key or press the line key
Description when the phone is idle.
Note: It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled). The value configured by the parameter "account.X.dialplan.digitmap.apply_to.press_send"
takes precedence over that configured by this parameter.
Permitted
0-Disabled
1-Enabled
Values
Default 1
Parameter dialplan.digitmap.apply_to.prefix_key
It enables or disables the phone to apply the predefined string of the digit map after pressing a Prefix
key.
Description
Note: It works only if "dialplan.digitmap.enable" or "account.X.dialplan.digitmap.enable" is set to 1
(Enabled).
Permitted
0-Disabled
Values 1-Enabled
Default 1

Digit Map for a Specific Line Configuration

The following table lists the parameters you can use to configure the digit map for a specific line.
Parameter account.X.dialplan.digitmap.enable
It enables or disables the digit map feature for a specific account.
Description
Note: The value configured by the parameter "account.X.dialplan.digitmap.enable" takes precedence
over that configured by the parameter "dialplan.digitmap.enable".
Permitted
0-Disabled
Values 1-Enabled
Default Blank
Parameter account.X.dialplan.digitmap.string
It configures the digit map pattern used for the dial plan.
Example:
account.1.dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Description
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC
3435. It works only if "account.X.dialplan.digitmap.enable" is set to 1 (Enabled). The value configured
by the parameter "account.X.dialplan.digitmap.string" takes precedence over that configured by the
parameter "dialplan.digitmap.string".
Permitted
String within 2048 characters
<y0000000000xx>.cfg
<y0000000000xx>.cfg
[1]
<MAC>.cfg
[1]
<MAC>.cfg
Call Features
403