Blf Key Led/Icon And Behavior For Dnd State Configuration; Blf Key For Intercom Configuration - Yealink SIP-T3 Administrator's Manual

For other phones, the BLF/BLF list DSS key LED glows green for 1000ms and then goes out.
Note: It works only if "blf.enhanced.hold.enable" is set to 1 (Enabled).
Permitted
String
Values
Default Blank
Supported
All phones except T48G, T46G, T42G, T41P, T30P, T30, T29G, T19(P) E2 and CP920
Devices

BLF Key LED/Icon and Behavior for DND State Configuration

The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for DND state
(DND is activated on the monitored phone).
Parameter blf.enhanced.dnd.enable
Description It enables or disables the custom configuration when DND is activated on the monitored phone.
0-Disabled
Permitted
Values
1-Enabled, the phone will display the custom BLF/BLF List DSS key LED status/icon colors.
Default 0
Supported
All phones except T48G, T46G, T42G, T41P, T30P, T30, T29G, T19(P) E2 and CP920
Devices
Parameter blf.enhanced.dnd.led
It configures the custom BLF/BLF List DSS key LED status/icon colors when DND is activated on the
monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.dnd.led = $LEDrd1000o100yd300$
Description
For T57W/T48U/T48S phones, an infinite loop for the BLF/BLF List DSS key field: displays a red icon
for 1000ms, turns to white for 100ms and then displays a yellow icon for 300ms.
For other phones, an infinite loop for the BLF/BLF list DSS key LED status: glows red for 1000ms, be
in the off state for 100ms and then glows yellow for 300ms.
Note: It works only if "blf.enhanced.dnd.enable" is set to 1 (Enabled).
Permitted
String
Values
Default Blank
Supported
All phones except T48G, T46G, T42G, T41P, T30P, T30, T29G, T19(P) E2 and CP920
Devices

BLF Key for Intercom Configuration

The BLF key (not include BLF List key) can also be used to initiate an intercom call.
The following table lists the parameter you can use to configure BLF key for Intercom.
Parameter features.blf.intercom_mode.enable
It enables or disables the phone to initiate an outgoing intercom call with a monitored user when
pressing the BLF key.
Description
Note: To use this feature, you also need to configure the intercom mode (configured by the parameter
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Advanced Features
500