Yealink SIP-T3 Administrator's Manual page 319

Transfer ring back - There is a call being transferred to another phone. Moreover, the phone is in the ringback
l
state.
Hold – The call is placed on hold on the phone.
l
Held – The call is held.
l
Conference – The phone sets up a conference call.
l
Dial tone –The phone is on the dialing screen without entering the number.
l
Dialing – The phone is on the dialing screen with entering the number but not dialing.
l
Note
: Configuring the custom soft keys may affect the softkey layout in different call states. For more information on softkey
Softkey Layout
layout, refer to
The following table lists the parameters you can use to configure EDK soft keys.
Parameter softkey.X.enable
It enables or disables the custom soft key X.
Description
Note: It works only if "features.enhanced_dss_keys.enable" is set to 1 (Enabled).
Permitted 0-Disabled
1-Enabled
Values
Default
0
Parameter softkey.X.label
It configures the text displayed on the soft key label.
Description
Note: It works only if "features.enhanced_dss_keys.enable" and "softkey.X.enable" are set to 1
(Enabled).
Permitted
String
Values
Default Blank
Parameter softkey.X.position
It configures the location on the phone screen for soft key X.
Description
Note: It works only if "features.enhanced_dss_keys.enable" and "softkey.X.enable" are set to 1
(Enabled).
Integer from 0 to 10
If it is set to 0, the soft key X is located in the first available position from the left.
Permitted
Values If it is set to other values, a More soft key appears and the soft key X is located in the specified pos-
ition. The following soft keys are moved by one position to the right. Press the More soft key to view
the remaining soft keys.
Default 0
Parameter softkey.X.action
It configures the action or function for custom soft key X.
This value uses the same macro action string syntax as an Enhanced DSS key.
You can also invoke the EDK macro that was already defined. The macro name follows the character
"!".
Description
Example:
softkey.1.action = !macro1
In this example, macro1 stands for the macro name configured by the parameter "edk.edk-
list.X.mname".
.
[1]
[1]
[1]
[1]
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
<y0000000000xx>.cfg
Phone Customization
313