TOHATSU MFS 25D Service Manual page 225

4. Install the power unit installation bolts and tighten them to
the specified torque in two steps in the order shown in the
diagram.
Apply water-resistant grease to the power unit
installation bolts.
Power Unit Installation Bolt:
First Tightening Torque:
15 N·m (11 lb·ft) [1.5 kgf·m]
Second Tightening Torque:
30 N·m (22 lb·ft) [3.0 kgf·m]
Connect the vapor separator drain hose 4, cooling water
5.
hose (drive shaft housing - vapor separator) 5, and the
vent hose 6.
6. Connect the cooling water hose (vapor separator - cooling
water check port) 7.
Connect the fuel hose 8.
7.
4st 25/30 2022
A S
B P
5
5-85