Table of Contents
Advertisement
5. Remote Control Components
1) Installation of the Remote Control
Cable (Remote Controller Side)
1.
Loosen the screws 1 on the rear panel and remove the
rear panel 2 .
2.
Screw about 11 mm (0.43 in) of the enclosed terminal
eye 4 into the threaded section at the end of the remote
control cable 3 and secure it with a nut 5 . Then, apply
grease on the mounting hole b of the terminal eye end.
Insert the outer groove c of the remote control cable for
3.
the shift 6 into the clamp groove of the housing. Next,
insert the terminal eye into the pin 8 at the end of the shift
arm 7 and secure it with the E-ring 9 .
4.
Insert the enclosed grommet 0 into the clamp groove.
5.
Follow the same procedure as the remote control cable for
the shift to install the remote control cable for the throttle
q in the throttle arm w.
6.
Fix the rear panel securely with 2 screws.
4st 25/30 2022
a Approx. 11 mm (0.43 in)
6 Remote control cable for the shift
7 Shift arm
10
10-9
Advertisement
Chapters
Table of Contents
