Replacement Of Oil Filter - TOHATSU MFS 25D Service Manual

• Apply engine oil on the sealing areas of the
engine oil drain bolt.
• Use a new gasket.
Engine Oil Drain Bolt:
24 N · m (18 lb · ft) [2.4 kgf · m]
5. Pour the specified amount of new engine oil into the
oil inlet 3 while checking the amount using the oil
level gauge 4.
6. Install the oil filler cap 1 as well as the oil level
gauge and start the engine to warm up for 5 minutes.
7. Check if there are any oil leaks and stop the engine.

6) Replacement of Oil Filter

1. Drain engine oil.
Remove the yellow plug 1 of the oil drip tray under the
2.
oil filter and attach the hose to the nipple of the tray (hose
inner diameter: 12.0 to 12.7 mm). Set a drain oil pan on
the opposite side of the hose.
3. Using the oil filter wrench, which is a special tool, turn the
oil filter counterclockwise to remove it.
Oil Filter Wrench 2 :
P/N. 3AC-99090-0
Replace the oil filter after 5 minutes or more after
stopping the engine.
4. Install the oil filter and tighten it to the specified torque
using the oil filter wrench.
Apply a thin coat of engine oil on the O-ring of the
oil filter before installing it.
Oil Filter:
18 N · m (13 lb · ft) [1.8 kgf · m]
5. Completely wipe off the spilled oil and attach the plug of
the oil drip tray.
4st 25/30 2022
3
3-7