Before working on the engine, check the installation condition of the hull, rigging and engine, and
make sure the fuel is normal and the battery is fully charged. For mechanical troubleshooting, refer to
the relevant troubleshooting section in this chapter. For checking and servicing the outboard motor,
refer to the service procedures described in this manual to perform the work safely.
Power Unit
State 1
Engine will not start or is hard to start.
Check that gear shift is
in neutral (N).
Neutral (N)?
Check operations of starter motor
or recoil starter.
Operates?
(Electric Start Model)
Check battery cables for defective
contact, ground lead wire securing
bolt for looseness or disconnection,
starter motor positive terminal for
break, and fuse if it is blown.
Normal?
Check operation of starter
solenoid.
Normal?
Go to next page.
4st 25/30 2022
Starting System
(Recoil Start Model)
9
9-3