Installation Of Propeller Shaft Housing Assy - TOHATSU MFS 25D Service Manual

Lower Unit
Insert and install the pump case (upper) y and gasket
7.
(one) into the pump case (lower) 6 from the upper end of
the drive shaft.
When installing the pump case (upper) y ,
install the case while turning the drive
shaft w clockwise so that the impeller
blades are not reverse to the direction of
engine rotation.
OBM
OBM OBM
Attach the water pipe seal u.
8.
Apply OBM grease thinly on the inside c of the
water pipe seal so that the water pipe can be
inserted smoothly.

35) Installation of Propeller Shaft Housing Assy

Install the O-ring 2 to the propeller shaft housing 1.
1.
Apply gear oil to the O-ring.
Install the clutch push rod 4, ball 5, and washer 6 that
2.
was removed during disassembly to the propeller shaft 3.
Install the propeller shaft to the propeller shaft housing 1,
3.
and install the assembly to the gear case.
• Install the propeller shaft housing to the gear
case securely, and tighten the installation bolts
after confirming that the O-ring is set in the case
properly.
• Apply ThreeBond 1342 to the threads of the
propeller shaft housing installation bolts.
1342
1342 1342
6-38
CAUTION
2 O-ring
Do not reuse.
4st 25/30 2022