TOHATSU MFS 25D Service Manual page 87

4. Turn the shift arm 4 to the Forward (F), Neutral (N)
or Reverse (R) position, then turn it to the Neutral (N)
position after confirming the position.
5. Adjust the screw-in amount of the cable joint 3 so that the
hole of the cable joint is aligned with the throttle arm and
shift arm pin a .
Screw in a minimum of 10 mm (0.39 in) b of
the cable joint.
• The cable joint is shipped together with the
outboard motor in the packing box.
• When adjusting the cable joint, adjust it with the
cable fully pushed in.
Tighten the nut 5 and install the cable joint on the pin
6.
before securing it with a washer and R pin 6 .
7. Operate the shift lever 2 and check whether it moves to
the Forward (F), Neutral (N) and Reverse (R) positions.
4st 25/30 2022
WARNING
N N
R R
F F
N
F
R
3
3-23