TOHATSU MFS 25D Service Manual page 57

Three
Loctite Konishi Konishi Emulsion
Bond
1741
425 G17 G103 P-80
(7782)
4st 25/30 2022
Oil
Shinetsu
Center Chuo Yuka
Silicone
Research
Cen
LOR FM- LM-
tax KS-64
#101 531 902
L2
Three
Sumico
Bond
Molytone
Grease ATF 5211
No.1
Remarks
Cam Unit
Bearing
Lip
Outer Surface, Press Fit
Thread
Bearing, Roller, Sliding Part
Entire Surface
Entire Surface
Outer Face
Shaft, Stem Head
Entire Surface
Entire Surface
Entire Surface
Lip and Inside
Entire Surface
Pour 2 cc from the suction inlet
O-Ring
Thread, Seat Surface
Thread
Thread
Entire Surface
Plunger Tip
Outer Face
Thread
Inner Wall
Ring Grooves, Outer Face, Piston Pin Hole
Entire Surface
Outer Face
Small End Inner Diameter
Seat, Underhead Lower Cylindrical Section,
Thread
Sliding Face, Thrust Face
Only for Bearing, Remove Grease of Outside.
Lip
Apply in a semicircle at a range 5mm (0.20 in)
from the insertion side.
O-Ring
Apply a thin coat on the mating surface in
contact with the O-ring.
Blank plug of the oil drip tray
2
2-27