Install the upper rubber mounts 6 and dampers 7 onto
4.
the drive shaft housing and tighten the bolts 8.
Install the dampers in the orientations shown in
the diagram.
Upper Rubber Mount Bolt:
13 N · m (9 lb · ft) [1.3 kgf · m]
7) Installation of Drive Shaft Housing Assy
Attach the damper 2 to the lower rubber mount 1, then
1.
attach the drive shaft housing to the clamp bracket assy.
Correctly align the bolt hole position of the
damper when installing.
Tighten the upper mount nuts 3 to the specified torque.
2.
Upper Mount Nut 3:
27 N · m (20 lb · ft) [2.7 kgf · m]
Install the lower mount bolt 4 and lower mount nut 5.
3.
Lower Mount Nut 5:
27 N · m (20 lb · ft) [2.7 kgf · m]
4st 25/30 2022
7
7-33