Connections To The Outboard Motor; Steering Cable - TOHATSU MFS 25D Service Manual

4. Connections to the Outboard
Motor

1) Steering Cable

Cable installed on the starboard side
1. Apply a thin coat of grease over the entire cable end.
2. Insert the steering cable into the tilt tube.
3. Tighten the nut to the specified torque.
Nut:
48 N·m (35 lb·ft) [4.8 kgf·m]
• Be sure to install the drag link seal ring 1.
• Do not overtighten the drag link seal ring or it
may deform and the telescopic shaft of steering
cable will not be sealed properly.
4st 25/30 2022
10
10-7