TOHATSU MFS 25D Service Manual page 390

Rigging
r/ in
With the control lever 5 on the remote control box at the
9.
neutral position, check that the free acceleration lever w is
at the fully closed position.
Operate the shift arm e to the forward (F), neutral (N),
10.
and reverse (R) positions to confirm the positions, then set
it to the neutral (N) position.
Adjust the screw-in amount of the cable joint r so that its
11.
holes are aligned with the pins b of the throttle arm and
the shift arm.
The cable joint should be screwed in at
least 10 mm.
• The cable joint is shipped in the outboard motor
packing box.
• When adjusting the cable joint, secure it with
the cable fully pushed in.
10-12
WARNING
N N
R R
e Cable joint screw-in amount
F F
4st 25/30 2022