TOHATSU MFS 25D Service Manual page 271

5. Install the shift rod joint, and connect the shift rod using a
new spring pin.
• Double-check that the shift rod is fully raised.
In addition, check that the shift lever is in the
forward (F) position. (Shift lever is in contact
with stopper)
If the joint is not tightened in the correct
position, shifting in and out may become
difficult.
• Install the spring pin with the opening facing up
or down.
Spring Pin Tool 3:
P/N. 345-72228-0
Install the shift rod joint retainer 4.
6.
Apply water-resistant grease on the shift rod joint
retainer.
4st 25/30 2022
a Stopper
6
6-41