Rigging
r/ in
1. Service Information
The installer shall ensure the work environment is safe by paying adequate attention to factors including fire prevention
and ventilation so as not to cause injuries or damage the product.
2. Service Data
1) Boat Mounting Restriction
Be careful not to overload the boat or mount an engine with an output that is too large for the boat. A plate indicating
the maximum permissible output and seating capacity set by the manufacturer according to specific standards is
displayed on the boat. If you have any doubts or questions, consult your dealer or the boat manufacturer.
Never mount an outboard motor exceeding the maximum output set by the boat
manufacturer as the following problems may occur.
· The boat may become uncontrollable.
· The design buoyancy characteristics of the boat may change by mounting an excessive
weight on the transom.
· In particular, cracks or damage may occur in the boat around the transom area.
An overpowered boat may cause serious injuries, death, or damage to the boat.
2) Mounting Dimensions
Transom Opening Smallest Dimension: a
1-engine mounted 696 mm (27.40 in)
2-engine mounted 1256 mm (49.45 in)
Minimum engine centerline distance when 2 engines are
mounted: b
560 mm (22.05 in)
When the mounting height of the outboard motor
is too high, the engine may overheat or the
components of the gear case may be damaged.
10-2
WARNING
a
a
b
4st 25/30 2022