Disconnect the pulse coil connector 5 and remove the
6.
fuse holder 6, battery cable 7, and ground lead wire 8.
Remove the coil bracket assembly 9.
7.
Turn the drive pulley 0 in the clockwise direction, and
8.
align the " " mark d of the drive pulley with the " " mark
e of the cylinder block. Then, make sure that the " I"
mark f of the driven pulley q and the " " mark g of the
cylinder head align.
The No.1 cylinder should be at the top dead
center of the compression stroke.
Crank Shaft Holder:
P/N. 3BJ-72815-0
Remove the timing belt w.
9.
Remove the timing belt from the driven pulley
side, and then remove it.
Do not turn the drive pulley (crank shaft) or
driven pulley with the timing belt removed.
Doing so can make the pistons and valves
interfere with each other, possibly resulting
in damage to these parts.
4st 25/30 2022
CAUTION
3
3-15