Inspection Items; Inspection Of Throttle Cable And Shift Cable; Installation Of Tiller Handle - TOHATSU MFS 25D Service Manual

Bracket

3. Inspection Items

1) Inspection of Throttle Cable and
Shift Cable
1. Check the operation of the throttle cable and shift cable.
2. Remove the tiller handle cover and check the cable inner
wire and outer wire for bending or damage. Replace if
necessary.
3. Operate the throttle fully closed and fully opened to check
whether the throttle drum is fully closed or fully opened.

2) Installation of Tiller Handle

Attach the cables to the throttle shaft 1 as shown in the
1.
diagram.
OBM
OBM OBM
Install the throttle shaft 1 with the cable attached to the
2.
tiller handle. Pay attention to the installation position of the
throttle friction 2.
Apply screw locking agent (ThreeBond 1342) to
the throttle shaft screw 3.
1342
1342 1342
Install the bushings 4 and washer 5 to the steering
3.
bracket 6.
OBM
OBM OBM
Attach the tiller handle assy to the steering bracket 6 and
4.
tighten the nut 7 to the specified torque.
• Apply a screw locking agent (ThreeBond 1342)
to the section a of the stud bolt 8.
• Attach the section a of the stud bolt to the tiller
handle side.
• Arrange the throttle cable as shown.
1342
1342 1342
7-28 4st 25/30 2022