Installation Of Steering Shaft - TOHATSU MFS 25D Service Manual

Pull out the steering shaft 4 from the swivel bracket assy
4.
to remove.
Remove the washer and then remove the O-ring
and collar from the steering bracket.
5. Check the individual parts.

9) Installation of Steering Shaft

Attach the thrust plate 1 and bushing 2 to the steering
1.
shaft.
2. Stand the swivel bracket assy vertically, and insert the
steering shaft into the swivel bracket assy.
3. Attach the bushing 3, new O-ring 4, and thrust plate 5
to the swivel bracket.
• Push the bushing by using a flathead screw
driver until it stops.
• Insert the O-ring until it contacts the bushing.
• Securely install the bushing and O-ring in the
swivel bracket.
OBM
OBM OBM
Install the lower rubber mount 6 and mount bracket 7.
4.
4st 25/30 2022
7
7-35