Table of Contents
Advertisement
Power Unit
Remove the starter pulley o.
14.
15.
Hoist and remove the power unit.
• Install the eye bolt p in the screw hole for
installing the starter pulley.
• When hoisting the power unit, do so carefully
while checking if the wires and hoses are
caught by other parts.
• Keep the power unit level by 2-point suspension
and lift straight upward as illustrated.
• When removing the power unit, check the oil
strainer hose routing.
Eye Bolt p:
Commercially available item (M6)
Remove the nipple 1, engine base gasket 2, and dowel
16.
pin 3 from the power unit.
5) Removal of Oil Strainer
Remove the oil strainer 2 from the oil strainer hose 1.
1.
Before removing the oil strainer hose, note the
arrangement of the hose.
6) Inspection of Oil Strainer
1.
Check the oil strainer for dirt and clogging. Clean or
replace if necessary.
5-34
4st 25/30 2022
Advertisement
Chapters
Table of Contents
