TOHATSU MFS 25D Service Manual page 90

Maintenance
5. Adjust the screw-in amount of the cable joint so that the
hole of the cable joint 3 is aligned with the throttle arm
and shift arm 4 pin a .
Screw in a minimum of 10 mm (0.39 in) b of
the cable joint.
• The cable joint is shipped together with the
outboard motor in the packing box.
• When adjusting the cable joint, adjust it with the
cable fully pushed in.
6. Tighten the nut 5 and install the cable joint on the pin
before securing it with a washer and R pin 6 .
7. Operate the control lever and check if it moves from the
Forward (F) to the Neutral (N) and to the Reverse (R)
positions.
3-26
WARNING
N
4st 25/30 2022