Table of Contents
Advertisement
8) Inspection of Vapor Separator
1.
Check the needle valve for bend and wear. Replace if
necessary.
2.
Check the float for deformation. Replace if necessary.
3.
Check the filter for dirt and clogging. Clean if necessary.
4.
Reinstall the needle valve, float and float pin, and check
that the parts moves smoothly.
Check the float height b as shown. Replace the float or
5.
needle valve if the height is out of the specified range.
Do not press the needle valve with the float.
Float Height b:
15.2 mm (0.598 in)
9) Reassembly of Vapor Separator
1.
Attach the float chamber to the vapor separator.
2.
Reassemble all parts that were removed.
Check that the hose is reconnected correctly.
4st 25/30 2022
4
4-37
Advertisement
Chapters
Table of Contents
