Table of Contents
Advertisement
17) Assembly of PT Motor
1.
Unlock the brush spring, push the brushes into the brush
holders, and install the armature.
Lock the brush spring.
2.
Check the O-ring and replace if necessary.
3.
Install the yoke assy to the motor base.
Cover the end of the armature shaft with a clean
cloth, hold the shaft with a pair of pliers, and
carefully install the armature so that it does not
get detached from the brushes.
4.
Align the knock and tighten the screw.
4st 25/30 2022
7
7-43
Advertisement
Chapters
Table of Contents
