Connecting Header Hydraulic And Electrical Systems - M2260 Windrower - MacDon R113 Unloading And Assembly Instructions

6.2 Connecting Header Hydraulic and Electrical Systems – M2260
Windrower
The header's electrical and hydraulic systems must be connected to the windrower. The procedure for connecting the
header's hydraulic and electrical systems to the windrower differs depending on the configuration of the windrower.
IMPORTANT:
The Low Pressure Case Drain kit (B6698) must be installed on the M2260 windrower before an R113 Rotary Disc Header
can be connected to it.
The procedure for connecting the header's hydraulic connections to the windrower depends on the windrower's
configuration:
• Auger/rotary disc/draper header-ready windrowers are equipped with a set of hydraulic quick couplers which are
compatible with the header drive hoses on the rotary disc header.
• Rotary disc header-ready windrowers are equipped with hard-plumbed hydraulic connections.
NOTE:
The hydraulic bundle includes a complete set of quick couplers that can be installed onto a windrower configured for use
with rotary disc headers.
Proceed to the relevant procedure:
For auger/rotary disc/draper-ready configuration (A), refer to
6.2.1 Auger/Rotary Disc/Draper-Ready Configuration – Quick
Coupler Connections, page 68
For rotary disc-only hard-plumbed configuration (A), refer to
6.2.2 Rotary Disc-Only Configuration – Hard-Plumbed Fittings,
page 71 for instructions.
262300
ATTACHING HYDRAULIC AND ELECTRICAL COMPONENTS
for instructions.
Figure 6.8: Header Hydraulics Configurations – Auger/
Rotary Disc/Draper-Ready
Figure 6.9: Header Hydraulics Configuration – Rotary
Disc-Ready with Hard-Plumbed Connections
67
A A
1036608
A A
Revision A