Additional Guidance To Functions And Features; Trigger Logic Functions; Wisefusion - Kemppi X5 FastMig Series Operating Manual

3.4 Additional guidance to functions and features

This section summarizes some of the X5 FastMig functions and features and how to use them.
The use of additional welding programs and Wise features is possible with the X5 FastMig Synergic equipment.
"Trigger logic functions" below
"WiseFusion" below
"WisePenetration+" on the next page
"WiseSteel" on the next page
"WeldEye with DCM (optional)" on page 84

3.4.1 Trigger logic functions

With X5 Wire Feeder 300 Manual you can select the trigger logic by pressing the
control panel.
With X5 Wire Feeder 300 Auto you can select the trigger logic in the
2T
In 2T, pressing the trigger ignites the arc. Releasing the trigger switches the arc off.
4T
In 4T, pressing the trigger starts the Pre gas, and releasing the trigger ignites the arc. Pressing the trigger again
switches the arc off. Releasing the trigger ends the Post gas.

3.4.2 WiseFusion

Available with automatic 1-MIG-enabled equipment only.
The WiseFusion welding function enables adaptive arc length control, which keeps the arc optimally short and
focused. WiseFusion increases the welding speed and penetration and decreases heat input. WiseFusion can be used
© Kemppi
trigger logic selection button
Welding parameters
82
X5 FastMig
Operating manual - EN
in the
view.
1920960 / 2039