3.2 Connecting gun
This section does not apply to Flexlite GC 223GMM welding gun. It comes factory-installed with MinarcMig Evo weld-
ing equipment.
Hand-tighten the gun connectors. Loose connectors may overheat, create contact disturbances, mechanical damage
and gas leakage.
For connecting the gun (and applicable extension parts), refer also to your welding equipment's instructions.
If not already preinstalled, the wire liner must be installed before connecting the gun. Refer to "Installing and replacing
wire liner" on the next page for instructions.
1.
Connect the gun to your welding equipment.
2.
Secure the connector in place by turning the collar clockwise.
© Kemppi
8
Flexlite GC
Operating manual - EN
1921860 / 2109