Olivetti d-Color MF4003 Service Manual page 306

d-Color MF4003/MF3303
CED DIS
TIMER2
Setting item
EOL-EOL To set the transmission time between EOLs. (*)
CFR-PIXWAIT Sets the waiting time from CFR is sent to the image signals are received.
Radio fax on boats occasionally requires more than 6 sec.
EOM-PIXWAIT Waiting time to receive PIX before sending DIS when EOM is used.
Some fax machines sends PIX without returning to Phase B in spite of EDM.
JM WAIT Time to continue outputting CM until receiving JM.
• *: EOL-EOL
1 line data
EOL EOL
Others
Setting item
ECM Function Set whether or not to cancel reception ECM (error correction mode).
Frame Size at ECM To set the frame size at ECM transmission.
TX
Cording Ability To set the coding ability.
Effective to both sending and reception.
16.7 List Output
NOTE
▪ This setting is displayed only for "Line1."
Report Addition Information
• To set whether or not to add the diagnosis code or dial number to the communication journal.
Setting value
Diagnosis Code The diagnosis code is printed on the communication journal.
Dial Number The dial number is printed on the communication journal.
OFF Do not apply diagnosis codes and dial numbers.
TX Result Report
• To set whether or not to add image to the transmission result report.
• Even if set to "With image" images are not attached at the time of the quick memory transmission and the manual transmission.
With image
Without image
Protocol Trace Auto Output
• To set the timing for the protocol trace auto output.
Always
Error
OFF
16.8 Function Parameter
Function parameters can be set through addressing.
NOTE
▪ To change the value in this address parameter list, comply with the telephone line regulation for each country.
▪ Depending on values that have been changed, compliance with the phone line standards of other countries may not be obtained.
Service Manual
DCS TCF PIX
PMC: Post Message Command
Contents
1 line data
Contents
Setting value
Setting value
PMC
Contents
I-90
I SERVICE MODE > 16. FAX
Setting value Default setting
4.0 to 25.5 s
(Step: 0.5 s)
6.0 to 25.5 s
(Step: 0.5 s)
5.5 to 25.5 s
(Step: 0.5 s)
6.0 to 25.5 s
(Step: 0.5 s)
Setting value Default setting
ON
OFF
64
256
MH
MH/MR
MH/MR/MMR
MH/MR/MMR/JBIG
Default setting
Default setting
○
Default setting
○
13.0 s
6.0 s
5.5 s
9.0 s
○
○
○
○
Y119930-3