Olivetti d-Color MF4003 Service Manual page 124

d-Color MF4003/MF3303
[1] [2]
10. To reinstall, reverse the order of removal.
Actions after replacement of the board
1. Turn ON the main power switch.
2. Check the firmware version of the SSD Controller.
I.6 Firmware Version
3. If the firmware version of the SSD Controller is not the latest, upgrade the firmware.
FIRMWARE
4. Turn OFF and ON the main power switch..
5. [Recover Data] appears on the panel, touch [Recover Data] to start the recovery of data.
6. Turn OFF and ON the main power switch.
7. If a data is acquired through the backup utility, conduct the recovery of data.
4.3.3 CPU board (CPUB)
NOTE
▪ Never use the combination of the used CPU board removed from another machine and the storage board. This combination
causes corruption of stored data. Note that the combination of the original CPU board and the used storage board removed from
another machine also causes the same problem.
▪ Never replace the CPU board and storage board with new one at the same time.
1. Remove the rear cover.
F.4.1.3 Rear cover
[3] [1] [2]
[1] [4]
[3] [2]
[3] [4]
[1]
[1]
Service Manual
[1]
[3]
[2]
F DISASSEMBLY/REASSEMBLY > 4. d-Color MF4003/MF3303
9. Remove the screw [1], and remove the storage board [2].
NOTE
▪ When mounting the storage board, insert it obliquely.
2. Remove the cable and ground wire from four wire saddles [1], and disconnect
the connector [2].
3. Remove the screw [3], and remove the plate [4].
4. Remove the cable from the edge cover [1], and disconnect the connector [2].
5. Remove five screws [3], and remove the plate [4].
6. Remove four screws [1], and remove the plate [2].
F-26
Y119930-3