Olivetti d-Color MF4003 Service Manual page 356

d-Color MF4003/MF3303
1.2.3 Count by the combination of each setting
• The count method depends on the combination of the Counter Setting.
• The following shows count methods that are the combination of each setting.
Total Counter
Mode 1
Mode 2
1.3 Management Function Choice
• To set whether or not the Key Counter, Management Device (Data controller), Authentication Device, or Vendor are to be mounted.
NOTE
▪ This is not displayed when [Administrator] -> [Security] -> [Enhanced Security Mode] is set to "ON".
▪ When the setting shows that [Management Device 2] or [Vendor 2] is mounted, the following applications will be invalid.
PC FAX transmission / HDD TWAIN/PS Box Operator / PS Scan Direct / PS Job Spooler / Fiery: Scan to Box
Also, [Administrator] -> [Security] -> [Function Management Settings] -> [Network Function Settings] will be set to "OFF".
1.3.1 Management Device 2
• To set whether or not the management device 2 is installed.
• Set when the management device 2 is mounted.
(1) Management setting
• To set the management method when the management device 2 is mounted.
NOTE
▪ The setting is not available when either "External Authentication server setting" of user authentication, "Password Only" of
account track, "Do Not Synchronize" of user authentication and account track or "ON" of public user access has been set with
[Administrator] -> [User Auth/Account Track] -> [Authentication Type].
Setting item
Mode 1 Use contact type device. (Logout with ID key is not allowed.)
Mode 2 Use non-contact type device. (Logout with ID key is allowed.)
(2) Billing Line
• To be displayed only when [Fax (Line 3)] and [Fax (Line 4)] are set to [Set] in [Service Mode] -> [System 2] -> [Option Board Status].
1.3.2 Vendor 2
• To set whether or not the vendor 2 is installed.
(1) Vendor
Message
• Select message of vendor.
Setting item
Type 1 Message for coin vendor
Type 2 Message for card keeper
Type 3 Message for both coin and card
(2) Billing Line
• To be displayed only when [Fax (Line 3)] and [Fax (Line 4)] are set to [Set] in [Service Mode] -> [System 2] -> [Option Board Status].
1.4 Authentication Device 2
• To set whether or not the authentication device 2 is installed.
• Set when the authentication unit (biometric type or card type) is mounted.
Setting item Contents
Card Uses IC card authentication system (AU-201S/OMNIKEY 5427CK (AU-205H)/YSoft card reader/USB keyboard
emulation card reader).
A response timeout interval is displayed. (The interval is unchangeable.)
Body Uses biometrics (finger vein) authentication system (AU-102)
Set a film timeout interval, capture trial time and authentication trial time.
Card 3 Uses IC card authentication device for PKI card system
It will be displayed only when [Service Mode] -> [System 2] -> [Software Switch Setting] shows that switch No. 12 is set
to [00000010]/[02] (bit value/HEX value).
Service Manual
J BILLING SETTING/ENHANCED SECURITY/DEBUG SETTINGS > 1. BILLING
Large Size Counter Mode
No count
Other than No count
No count
Other than No count
J-2
Paper size
-
Except for large size
Large size
-
Except for large size
Large size
Contents
Contents
SETTING
Count
1 count
1 count
1 count
1 count
1 count
2 counts
Y119930-3