Olivetti d-Color MF4003 Service Manual page 681

d-Color MF4003/MF3303
(b) Protocol sequence example
8.2.3 Transmission function
(1) Original scan mode
• The original scan mode is roughly classified by the regular original scan and the irregular original scan.
Regular original
Normal mode
Mixed original mode
(a) Scan mode default setting
• The scan mode can be set by [Service Mode] -> [FAX] -> [System] -> [Scan Setting]. The default is the irregular mode.
Irregular mode Trailing edge detection
Normal mode DF paper size sensor
8.2.4 Reception function
(1) Reduction / division of reception
• Parameters related to reduction / division are set on the [Administrator Settings] -> [Fax Settings] -> [TX/RX Settings]. There are two
parameters as follows:
• [Min. Reduction for RX Print]: 96, 95, 94, ..., 87: a
• [Print Separate Fax Pages]: ON, OFF: b
• The reception recording mode is determined by the above-mentioned parameters, a and b.
(a) Auto reduction reception mode
• a = Don't care (except 100)
• b = OFF
• The received documents are automatically reduced in the range of 35 to 96 %.
(b) Page division recording reception mode
• a = 96, 95, ..., 87
• b = ON
• Documents are reduced to three reduction rate (90 %, 86 %, or 82 %) determined by the width of received documents and the selected
recording paper. When they are still larger than a paper size, they are reduced to a value in "a" for the division recording.
• 90% = Fixed value
• 86%, 82% = Reduction rate determined by the main scanning direction
• The paper selection and division are determined in accordance with the following figure.
(c) Paper selected for division printing, magnification
A4S width at reception
Original Optimum
length=Receive paper
d original
size*(1/a)
152 mm or less A5
153 to 311 mm A4S
Y119930-3
Calling Called
Call
(NSF)/(CSI)/DIS
SID/SUB/(TSI)/DCS
TCF
CFR
PIX
EOM
MCF
(NSF)/(CSI)/DIS
(TSI)/DCS
TCF
CFR
PIX
EOP
MCF
DCN
Irregular mode
Paper size detection
Automatically selected when using the page
related application function (book transmission,
etc.).
Priority 1 Priority 2
A5/a % A5S/69 % A4S/a %
A4S/a % A4/a % B4/a %
Irregular original
Default
○
Selected paper size / Division operation
Priority 3 Priority 4 Priority 5
A4/a % B5S/84 %
A3/a %
P-107
P THEORY OF OPERATION > 8. FK-517
Mode selection
Default setting
Scan setting
Frame erasure
Trailing edge erasure may not be
done.
Frame erasure of all sides
Priority 6 Priority 7
B5/a % B4/a %
- - -
Priority 8
A3/a %
-
Service Manual