Olivetti d-Color MF4003 Service Manual page 197

d-Color MF4003/MF3303
8. Storage Management
Function Name
Check Capacity
Overwrite All Data + Format
Overwrite All Data - Report Settings
Storage Lock Password
Format
Encrypt Settings
Debug Log Encryption Settings
Y119930-3
-
-
-
• Don't forget the lock password.
• After setting a lock password, if you replace the MFP storage due to its breakage or other reasons
and install a new MFP storage, an error message is displayed. In that case, clear the lock
password and set a new password using this function.
• It is subject to logical formatting here, therefore if starting with physical formatting, follow as
[Service Mode] -> [State Confirmation] -> [Memory/Storage Adjustment] -> [Format].
• Make sure to configure the following settings after formatting the storage.
• Installing the firmware.
• Reinstall movie data, voice data, OCR dictionary data, and PDF/A fonts from [Service Mode] -
> [System 2] -> [Install Data].
• Make sure to install the firmware after the format. Otherwise a trouble code "C-D012 Mount error
due to storage being unformatted" will appear.
• Use: To set a password used to encrypt data when storing it into the MFP storage.
• Default setting: 01234567890123456789
• For details of the functions, refer to
• Use: To set a password used to encrypt debug data when storing it into the MFP storage.
• Default setting: 01234567890123456789
• For details of the functions, refer to "
Function/Precondition
"Encrypt Settings."
H.12.7.2 Debug Log Encryption
H-29
H UTILITY MODE > 8. Storage Management
Settings."
Service Manual