Olivetti d-Color MF4003 Service Manual page 192

d-Color MF4003/MF3303
Key name
Receive Mode
Number of RX Call Rings
(Receive Time Interval Setting)
Number of Redials
Redial Interval
Manual RX V34 Setting
TEL/FAX Auto Switch (Only for
Japan)
External Phone Call Monitor
Sound (Only for Japan)
External Phone Call Time (Only
for Japan)
Audio Recognition Setting (Only
for Japan)
External Phone Disconnection
(Only for Japan)
Answering Machine Connection
Settings (Only for Japan)
Line Monitor Sound
Line Monitor Sound Volume
(Send)
Line Monitor Sound Volume
(Receive)
Pause Time
Ring Detection Pattern
6.10.3 TX/RX Settings
Key name
Duplex Print (RX) It will not be displayed when [Administrator] -> [Fax Settings] -> [TX/RX Settings] -> [Print Separate Fax Pages] is
set to "ON."
Letter/Ledger over A4/A3 -
Print Paper Selection -
Print Paper Size To make the setting of Print Paper Size enable, set [Administrator] -> [Fax Settings] -> [TX/RX Settings] -> [Paper
Tray Setting] to "Auto."
Incorrect User Box No. -
Entry
RX from Rejected Fax No.
(Only for Japan)
Paper Tray Setting -
Allow Paper Tray Setting -
Min. Reduction for RX -
Print
Print Separate Fax Pages It will not be displayed when [Administrator] -> [Fax Settings] -> [TX/RX Settings] -> [Duplex Print (RX)] is set to
"ON."
File After Polling TX -
No. of Sets (RX) -
Individual Receiving Line It will be displayed only when multiple lines are used and [Administrator] -> [Fax Settings] -> [Multi Line Settings] ->
Setup [Fax Line 2 to 4] -> [Multi Line Settings] -> [Line 2 to 4 Setting] is set to "TX and RX" or "RX Only".
Individual Sender Line It will be displayed only when multiple lines are used and [Administrator] -> [Fax Settings] -> [Multi Line Settings] ->
Setup [Fax Line 2 to 4] -> [Multi Line Settings] -> [Line 2 to 4 Setting] is set to "TX and RX" or "RX Only".
TX-Line Auto Switch -
Setting
Fax Rx Print Setting -
6.10.4 Function Setting
Key name
Function ON/OFF Setting F-Code TX
Relay RX
Relay Printing
Service Manual
It will not be displayed when [Service Mode] -> [Billing Setting] -> [Management Function Choice] shows that
"Management Device 2" is mounted.
When [Service Mode] -> [FAX] -> [Network] -> [Network Setting 1] -> [Receive Signal Detection Mode] is set
to "Time", [Receive Time Interval Setting] will be displayed.
It will not be displayed when [Service Mode] -> [Billing Setting] -> [Management Function Choice] shows that
the "Vendor 2" is mounted.
-
-
It will be displayed when [Administrator] -> [Fax Settings] -> [Line Parameter Setting] -> [TEL/FAX Auto
Switch] is set to "ON."
-
-
-
-
-
-
This setting is available only on the New Zealand model.
• It will be displayed when [Service Mode] -> [FAX] -> [System] -> [Display Setting] -> [Reject Calls] is set to
"ON."
• [Administrator] -> [Fax Settings] -> [Function Setting] -> [Function ON/OFF Setting] -> [Number Display
Function] is set to "ON."
-
It will be displayed when [Service Mode] -> [FAX] -> [System] -> [Display Setting] ->
[Relay] is set to "ON."
Function/Precondition
Function/Precondition
Function/Precondition
H-24
H UTILITY MODE > 6. Administrator
Y119930-3