Olivetti d-Color MF4003 Service Manual page 395

d-Color MF4003/MF3303
4. Auto Update setting
4.1 Service environment
• To use the "Auto Update setting", the MFP must be connected to such a network environment that the firmware data can be downloaded
on the network using the SMB or http protocol.
• The Auto Update function will not operate when the MFP is under the following conditions.
• Main power switch is set to OFF.
• Sub power OFF mode (power key is orange) or ErP auto power OFF mode (power key flashes orange) enabled
• [Administrator] -> [Security] -> [Enhanced Security Mode] is set to "ON".
• MFP is operating, or there are jobs present (including appointed jobs).
• MFP is in idle with suspended job.
• Trouble has occurred.
• Image file is in the memory.
• Model or the circuit board of the program does not match.
4.2 Preparation
• For using this Auto Update setting effectively, before executing the following procedures contact with the administrator to obtain an
agreement.
• Convert the obtained firmware data to an appropriate format. Refer to "
• Create the program update information file (C_UpdateList.ini).
• Upload the firmware data and program update information file to the program server.
• Configure the settings related to the automatic update function in [Service Mode] -> [Machine Update Setting] -> [Machine Auto Update
setting] -> [Auto Update setting].
• For details, see " I.18.2.1 Auto Update
4.3 Rewriting of Firmware
Download
• The program server is accessed at the configured polling interval to check the program update information file.
• Compare the program update information file in the program server with that in the MFP, and starts downloading the firmware data with a
changed Version number.
Auto Update of firmware
• If the MFP power is set to ON at the scheduled update time, rewriting is executed automatically. If the power is set to OFF, no rewriting will
be executed.
Y119930-3
setting."
K-7
K FIRMWARE > 4. Auto Update setting
K.3.2.1 Making the firmware data."
Service Manual