Olivetti d-Color MF4003 Service Manual page 491

d-Color MF4003/MF3303
8. CS Remote Analysis ERROR CODE
8.1 When connecting by SOAP
NOTE
▪ When a code other than the ones listed below is displayed, contact OLI and inform the error code.
8.1.1 1###
Error code
1001 Communication timeout.
• Reception time out occurred.
1002 Command error
8.1.2 2###
Error code
2001 SOAP request result problem
• An error occurred.
2002 SOAP request result problem
• Proxy server authentication failed.
2003 SOAP request result problem
• There isn't support of http version.
2004 SOAP request result problem
• Failed to connect.
2005 SOAP request result problem
• An error occurred while sending.
2006 SOAP request result problem
• Time out occurred while sending.
2007 SOAP request result problem
• An invalid request URL is specified.
2008 SOAP request result problem
• Content-Length or receive size exceeded the specified max.
transfer size.
2009 SOAP request result problem
• The size of the message body is too large.
200A SOAP request result problem
• The proxy server was set to enabled, but the proxy server host
was not set.
200B SOAP request result problem
• The proxy server refused CONNECT request.
200C SOAP request result problem
• Other errors were sent from the proxy server.
200D SOAP request result problem
• Connection to the proxy server failed.
200E SOAP request result problem
• The process is cancelled by an internal reset.
200F SOAP request result problem
• Other internal error occurred.
2010 SOAP request result problem
• Internal error occurred. (Task start)
2011 SOAP request result problem
• Internal error occurred. (MSG)
2012 SOAP request result problem
• Internal error occurred.
2013 SOAP request result problem
• As the device application specified MIO_REQBODY_ERROR,
process was stopped.
Y119930-3
L TROUBLESHOOTING > 8. CS Remote Analysis ERROR CODE
Contents
Contents
L-93
Solution
[MFP side]
Check the SOAP server system settings.
• Authentication setting for address of the
destination where the server is connected
• Location indicated for a folder
• Connection ID
• Password
Check the network environment (whether LAN is
disconnected or etc).
[Server side]
Check whether the server has started up or etc.
Contact OLI and inform the error code
Solution
Check the SOAP server system settings.
• Authentication setting for address of the
destination where the server is connected
• Location indicated for a folder
• Connection ID
• Password
Service Manual