Olivetti d-Color MF4003 Service Manual page 259

d-Color MF4003/MF3303
10. System 2
10.1 Storage type setting
• To set the installation status of the MFP storage.
Storage
microSD
10.2 Option Board Status
• To be used for setup of the optional fax kit.
Setting item
FAX (circuit 1)
10.3 Consumable Life Reminder
• To select whether or not to give the display of PM parts lifetime
NOTICE
• PM parts lifetime display: An entire screen warning is given when the service life of a specific unit has been reached, prompting the
user to replace the part.
• Applicable units:
• Drum Unit, Fusing Unit, Transfer Roller Unit, Image Transfer Belt Unit, Toner Filter
Setting value
Yes When the service life has been reached, a malfunction code and an entire screen warning appear on the
control panel.
No When the service life has been reached, a malfunction code and a message appear in one line on the upper
side of the screen.
10.4 Unit Change
10.4.1 Unit Change
• To select who is to replace a unit.
• When the unit life arrives, the warning display is intended for the specific person who is going to replace the unit.
• When "User" is selected: Printing is inhibited.
• When "Service" is selected: Life warning.
Setting item
Toner Cartridge
Imaging Unit
Waste Toner Box
10.4.2 Warning display
Toner Near Empty
• To set whether to display a toner near empty warning.
Yes
No
Near Empty Display Time
• To change the timing of toner cartridge near empty detection in order to optimize the timing of the toner cartridge replacement depending
on individual use (PV).
• To specify the timing for displaying toner near empty warning at a percentage against 100% of a full toner cartridge state.
NOTE
▪ The Near Empty Display Time will be displayed when "Bit Assignment 00000010 / HEX Assignment 02" is set for the Switch No.
"151" through the following settings. [Service Mode] -> [System 2] -> [Software Switch Setting].
▪ The toner cartridge is not provided with a mechanism that detects the amount of residual toner in the cartridge. So note that
when the toner cartridge is replaced in the midway, the display timing that was set as a reference and the amount of the residual
toner inside the toner cartridge may get mismatched.
▪ When [0] is specified, and the toner near empty warning display is specified to [No], no toner near empty warning will be
displayed but a toner empty stop warning will appear.
Y119930-3
Setting value
Set
Unset
Setting Value
User
Service
User
Service
User
Service
Setting value
Setting value
Contents
Japan
○
○
○
I-43
I SERVICE MODE > 10. System 2
Default setting
○
Default setting
○
Default setting
Default setting
US
○
○
○
Default setting
○
Service Manual
○
Europe
○
○
○