Olivetti d-Color MF4003 Service Manual page 302

d-Color MF4003/MF3303
16.3 Network
Network
Setting 1
Setting item
Receive Signal To set whether to detect the receive signal by the number of times or by time.
Detection Mode Sets to "Time" when ringer can not be detected by the number.
BUSY TONE To set whether or not to use the Busy Tone detection.
Detection
No. of Times of Busy To set the number of times of Busy Tone detection.
Tone Detection 0 time shows no detection is done.
• *: No. of Times of Busy Tone Detection
Toot
1
Network Setting 2
Setting item
1300Hz Detection To set whether or not to use the 1300 Hz detection.
Set this function to "ON" if the facsimile network (F-net) is to be used.
Dial Tone Detection To set whether or not to use the Dial Tone detection.
DC-LOOP Check Checks the DC loop current before dialing.
When the current is zero, an error occurs. (T.80)
You can change the setting to be compliant to standards in other countries. In
Japan, set this parameter to OFF.
min. RING OFF Time Minimum time to recognize ringer interval.
Response Waiting To set the response waiting time.
Time Response waiting timer (55 sec.)
• Calling: Starts after dialing. Until CED is received.
Pause Time The pause time for one pause key (pause between digits)
• *: min. RING OFF Time
a
• a: To avoid judging "a" as a ring-off time.
• b: Ring-off time
Network Setting 3
NOTE
▪ This setting is displayed only when "Line1" is selected.
▪ This setting is displayed only when the "Fax Target" is set to "JP."
Setting item
Pseudo-RBT Format To set a pseudo ring back tone format to be send back to the calling side.
Pseudo-RBT TX To set the transmission level for the pseudo ring back tone.
Level
Network Settings4, Network Settings5
• Network Settings4: To make settings for PBX dial tone signals received from PBX.
• Network Settings5: To make settings for 1st dial tone signals received from public line.
Setting item
Tone Det. Set. To execute the tone detection setting. Continuous
Service Manual
Contents
Toot Toot
2 3
Contents
a
b
Contents
Contents
Toot
When the number of tones is
set to three, judged to be busy
here.
Setting
value
Network Settings4
Sound
I-86
I SERVICE MODE > 16. FAX
Setting value Default setting
No. of Times
Time
ON
○ (JP/US)
OFF
○ (EU)
0 to 15 count 2 (JP/US)
(Step: 1 count) 3 (EU)
Setting value Default setting
ON
OFF
ON
OFF
ON
OFF
0 to 1000 ms 200 ms (JP)
(Step: 100 ms) 0 ms (US/EU)
35 to 115 s
(Step: 1 s)
1 to 7 s
(Step: 1 s)
Setting value Default setting
Japan
US
GB
GE
None
-15 to -10 dBm -10 dBm
(Step: 1 dBm)
Default setting
Network Settings5
○
Y119930-3
○
○
○
○
55 s
1 s
○