Olivetti d-Color MF4003 Service Manual page 258

d-Color MF4003/MF3303
Operation Service Mode
mode
Warm-up
6
7 Mode 4
9.10 Machine State LED Setting
• Configure the display method used when displaying the main body status with state display LEDs.
Setting item
Warning Status
<LED display forms for each type>
Warning Status
Paper Remainder
9.11 TP Level
• To adjust the selectivity of the touch panel.
-2 to +2 (step: 1*)
<Procedure>
1. Enter the new setting from the [+] / [-] key.
• To increase sensitivity of the touch panel, increase the setting value.
• To decrease sensitivity of the touch panel, decrease the setting value.
2. Touch [END].
NOTE
▪ When the setting has been changed, turn off the main power switch and turn it on again more than 10 seconds after.
9.12 Burn Prevention Settings
• To prompt to prevent a burn injury by displaying a message indicating that the fusing unit is at a high temperature when the right door has
to be opened in order to get rid of a paper jam.
Enable
Disable
Service Manual
Target user
Choice of
high humidity
circumstance
ON Want to prevent curling
immediately after warm-up
Want to print quickly
Want to prevent curling
when humidity is high
OFF Want to prevent curling
immediately after warm-up
ON
Type 1
Type 2
Machine State LED Setting
Attention
• Toner supply door open
• Toner cartridge install failure
• Toner Empty
• Near life
• Toner Near Empty
Malfunction code
Problem Unit Isolation
Fatal error
• Trouble code
• Jam
• Door opened
• Life stop
• Toner Empty Stop
Not used
Setting range
Setting item
Advantages
Warm-up time is as specified value
or later
Decreases possibility curling
occurs
Decreases possibility curling
occurs
Setting value
Blinking
Blinking
Blinking
Blinking
Lit
I-42
I SERVICE MODE > 9. System 1
Disadvantages
Productivity immediately after
warm-up decreases
Warm-up time long in high
humidity (65 seconds or less)
Long warm-up time (65 seconds or
less)
Default setting
○
Type 1 Type 2
Blinking
Blinking
Blinking
Blinking
Lit
Default setting
0
Default setting
○
Y119930-3