Olivetti d-Color MF4003 Service Manual page 182

d-Color MF4003/MF3303
6.3.13 Scan File Name Settings
Key name
Function Mode Initial
Supplementary File Name
6.3.14 Set Paper Name by User
Key name
Set Paper Name by User
Edit Paper Name
6.3.15 Enlarge Display Settings
Key name
Default Enlarge Display Setting
Enlarge Display Setting
Apply Basic Setting to Enlarge
Display
6.3.16 Registered Key Settings
Key name
Registered Key 1
Registered Key 2
Registered Key 3
Registered Key 4
Registered Key 5
6.3.17 Main Menu Display Settings
Key name
Main Menu Display Settings
6.3.18 Preview Settings
Key name
Realtime Preview
Set key Initial display
Original direction Setting
Preview Display Conditions
(Standard Application)
Preview Display Conditions
(Registered Application)
6.3.19 List/Counter
Key name
Meter Count and Device
Confirmation Tx Settings
Management List
Paper Size/Type Counter
Meter Counter List
Check Consumables List
TX Operation Log Output
6.3.20 Custom Function Pattern Selection
Key name
Custom Function Pattern Selection When a custom function pattern is registered or imported in [Service Mode] -> [System 2] -> [Custom
Service Manual
-
-
-
It will be displayed when Set Paper Name by User is enabled.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
• The counter information is collected via CS Remote Care.
• Though this setting is enabled, the information is not sent if [Service Mode] -> [System 2] -> [Acquiring
Settings] is set to "OFF."
It will not be displayed when [Service Mode] -> [Billing Setting] -> [Management Function Choice] is set to
"Vendor 2." (It will be displayed when the Key Counter is mounted when [Service Mode] -> [System 2] ->
[Software Switch Setting] shows that switch No.33 is set to [00000001] at Bit assignment/[01] at HEX
assignment.)
-
Setting will be available when [Service Mode] -> [Billing Setting] -> [Management Function Choice] shows that
"Management device 2" or "Vendor 2" is mounted.
This is displayed when [Administrator] -> [Security] -> [TX Operation Log Setting] is set to "On."
Pattern], the pattern ([Custom Pattern 1] to [Custom Pattern 3]) also can be selected.
Function/Precondition
Function/Precondition
Function/Precondition
Function/Precondition
Function/Precondition
Function/Precondition
Function/Precondition
Function/Precondition
H-14
H UTILITY MODE > 6. Administrator
Y119930-3