Olivetti d-Color MF4003 Service Manual page 410

d-Color MF4003/MF3303
Step
• Multi code: 1
6 M1 load check
• Check code: 40
• Multi code: 1, 2
7 Replace BASEB.
1.9.2 93-03
Contents
JAM type Misfeed at duplex transport section
JAM code 93-03
JAM detection timing
Misfeed processing Right door
location
Relevant parts
Procedure
Step
1 Initial check items
2 PS11 I/O check, sensor check
3 PS13 I/O check, sensor check
4 CL5 load check
• Check code: 81
• Multi code: 1
5 CL6 load check
• Check code: 80
• Multi code: 1
6 CL7 load check
• Check code: 80
• Multi code: 2
7 M1 load check
• Check code: 40
• Multi code: 1, 2
8 M3 load check
• Check code: 45
• Multi code: 1, 2, 3
9 Replace BASEB.
1.9.3 99-01
Contents
JAM type Controller JAM (paper size error)
JAM code 99-01
JAM detection timing
Misfeed processing
location
Relevant parts
Service Manual
Action
93-03 The leading edge of the paper is not turned ON (unblocked) the ADU transport sensor (PS11) even
after the lapse of a given period of time after the paper has turned OFF (blocked) the paper exit
sensor (PS13).
- Paper jam of a sheet of paper left at the duplex transport section results, if the ADU transport
sensor (PS11) is turned ON (unblocked) when the main power switch is turned ON, a door is
opened and closed, or a misfeed or malfunction is reset.
- Paper jam of a sheet of paper left at the duplex transport section results, if a sheet of paper is
determined to exist at a position detected when the main power switch is turned ON, a door is
opened and closed, or a misfeed or malfunction is reset.
• Main motor (M1)
• Fusing motor (M3)
• ADU transport clutch (CL5)
• ADU forward rotation clutch (CL6)
• ADU reverse rotation clutch (CL7)
• ADU transport sensor (PS11)
• Paper exit sensor (PS13)
• Base board (BASEB)
Action
99-01 • As a result of a paper size error, the controller transmits a forced stop command to the printer
engine and the printer engine is internally processing the size error.
• As a result of a paper size error, the controller transmits a forced stop command to the printer
engine; but the paper causing the size error cannot be fed out.
Control signal
BASEB CN17E-1 to 5
-
Control signal
-
BASEB CN23E-6 (ON)
BASEB CN16E-3 (ON)
BASEB CN23E-12 (ON)
BASEB CN18E-6 (ON)
BASEB CN18E-8 (ON)
BASEB CN17E-1 to 5
BASEB CN17E-6 to 10
-
-
-
L-12
L TROUBLESHOOTING > 1. JAM CODE
Location of electrical component
1-C
-
Location of electrical component
-
9-K
11-K
9-K
2-C
3-C
1-C
1-C
-
Y119930-3