Olivetti d-Color MF4003 Service Manual page 239

d-Color MF4003/MF3303
Initial Transmission
• Touching the Initial Transmission key will sent the information to the CS Remote Care center to register the machine.
(b) Date & Time Setting
• To set the data and time-of-day.
<Procedure>
1. Touch [Date & Time Setting].
2. Enter the date (month, day and year), time-of-day, and the time zone from the 10-key pad.
3. Touch [SET] to start the clock.
(c) RAM Clear
• To clear the following data at the center.
• Service ID, Basic setting, Date & time setting (time zone), Software SW setting, AT command
• To be used for setting CS Remote Care.
• To be used for reset the every data of the center to default.
NOTE
▪ If RAM clear is selected during transmission, RAM clear processing will be implemented at the time the transmission is
completed regardless of whether it is done properly or not.
Set
Unset
(d) Communication Log Print
• To print out the communication log.
• It will be displayed when "Fax" is selected in System Setting.
<Procedure>
1. Touch [Communication Log Print].
2. Load a paper tray with A4S/A4 or 81/2 x 11S/81/2 x 11 paper.
3. Select [1-Sided] or [2-Sided].
4. Press Start key to print out the communication log.
(e) Software Switch Setting
• To change the CS Remote Care settings.
NOTE
▪ Software SW bits data are written into the MFP storage every time a change is made. In case you changed bit data by
accident, be sure to restore the previous state.
▪ Do not change any bit not described on this table.
<Procedure>
1. Touch [Software Switch Setting].
2. Touch [Switch No.], and input the software switch number (two digits) using the 10-key pad.
3. Touch [Bit Assignment], and select software switch bit number using the arrow keys, and input 0 or 1 using the 10-key pad. (For setting
by hexadecimal numbers, touch [HEX Assignment] key, and input using the 10-key pad or A to F keys.)
• Refer to " I.8.2 Software SW setting for Remote
4. Touch [Fix].
(f) Response Time Out
• Set the timeout until the response arrives from the center during e-mail communication.
• This setting is available only when "E-Mail1" or "E-Mail2" is selected in [System Setting].
10 to 1440
(g) AT Command
• To set the command to be issued at the time of modem initialization.
• Enter the command and touch [SET] to register.
• This setting is available only when [Modem] is selected in [System Setting].
(h) Notification Setting
• To make the settings of notification to the center that is performed under unilateral communication via http.
• This setting is available only when [http2] is selected in [System Setting].
Schedule
• Set the schedule of notification to the center.
• Up to three different notification schedules can be registered.
<Procedure>
1. Select the key of the registration number, and then touch [Enable].
2. Select the notification cycle from [Day], [Week], or [Month].
• When selecting [Day] for the notification cycle, set the Day Frequency.
• When selecting [Week] for the notification cycle, set the Week Frequency and day of the week.
• When selecting [Month], set the Month Frequency and the date of the month.
3. Touch [SET] to register the schedule.
Center Notifi. Item
• To set whether or not to notify the Center.
Y119930-3
Setting value
Setting range
Care" for the setting items.
I-23
I SERVICE MODE > 8. CS Remote
Default setting
○
Default setting
60 minutes
Service Manual