1. Position the base back cover onto the frame weldment and display mount weldments.
Secure using the two #3 Phillips screws at the front and top of the base back cover.
Fully tighten the screws.
2. Reinstall the base front cover, see
installation.
Drive Ramp Transition Cover Replacement
This procedure replaces the Drive Ramp Transition cover.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"" on
page 73. Retain part(s) and/or fastener(s) for
6 Replacement Procedures
Covers and Panels Replacement
Page 76