Verify Hardware Validation Diagnostic Tests; Verify That There Are No New Error Codes - Precor Experience Series Service Manual

Verify hardware validation diagnostic tests

Perform the equipment
screen consoles) to help isolate the cause of the issue. These tests will help identify failed
system components. Resolve any resulting failures.

Verify that there are no new error codes

After correcting the issue, reopen the Error Log and verify that there are no remaining active
error codes. This will verify that the original error codes are not recurring and that there are
no new error code issues. If the error code is recurring, the issue may be mileage related,
review the error code odometer history to verify if the error event is related to mileage inter-
vals.
Clear the Error Log, see
Note: If there are no logged error codes and the issue persists, you will need to
use observable and audible indicators to identify the source of the failure. Also
make sure that there are no related service bulletins that may resolve the issue.
Browse the list of available Troubleshooting procedures for related Troubleshoot-
ing information.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Hardware Validation Tests
"Error Log & CPA Event Log" on
(LED consoles) or System Tests
page 182.
7 Troubleshooting
Troubleshooting Steps
(Touch-
Page 177