Ramp Replacement
About
This procedure provides instruction to remove and install the Ramp Assembly.
Specifications
System Component
Ramp Front Mounting bolts
Ramp Nut Plate bolts
Procedure
Review entire procedure before starting.
Removal
1. Remove the Front Top cover (see
page 66), Side covers (see
"Drive Ramp Transition Cover Replacement" on
2. Remove the left and right stairarms, see
3. Remove the two front mounting bolts, flat washers, and nuts . Retain part(s) and/or
fastener(s) for installation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
204 in-lbs +/- 60 (23 Nm +/- 6.8)
96 in-lbs (10.8 Nm)
"" on
page 64), Front Rear cover (see
"" on
page 68), and the Drive Ramp Transition cover (see
"Stairarm Replacement" on
6 Replacement Procedures
Specification
page 76).
page 152.
Ramp Replacement
"" on
Page 169