Videos; Procedure - Precor Experience Series Service Manual

Videos

EFX600/700/800 Dual Stage Input Drive
Belt Tension Verification

Procedure

Review entire procedure before starting.
1. Remove the drive disk access cover, see
2. Remove the left Drive Disk cove, see
3. Measure and verify that the first stage drive belt tension is within specification, see
"First Stage Drive Belt Tension Adjustment" on
within specification, retention the belt.
IMPORTANT: Adjust the first stage drive belt tension prior to adjusting the second
stage drive belt tension.
4. Use a 1/2" socket to loosen the two Generator/Brake Assembly bolt nuts (left side)
just enough to allow assembly movement. Do not remove the carriage bolt nuts.
CAUTION: Make sure that the two Generator/Brake Assembly carriage bolts are
loosened before adjusting the second stage belt tensioner. The tensioner hard-
ware can be damaged and the belt cannot be tensioned if the Generator/Brake
Assembly are not loosened.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Service Video
" > " on
Second Stage Drive Belt Tension Adjustment
EFX600/700/800 Dual Stage Input
Drive Belt Tension Verification
"" on page 78.
page 80.
page 52. If the belt tension is not
5 Adjustment Procedures
Link
Page 57