Precor Experience Series Service Manual page 119

Installation Instructions
1. Position the Generator/Eddy Brake assembly onto the Step-up Pulley/Tensioner
assembly.
2. Slide the Generator/Eddy Brake assembly downward and install the upper carriage
bolt. Tighten the bolt just enough to keep the carriage bolt head inserted into the
mounting slot but do not fully tighten. Then slide the assembly upward and install the
lower carriage bolt. Tighten the bolt just enough to keep the carriage bolt head inser-
ted into the mounting slot but do not fully tighten.
TIP: Install the upper carriage bolt fastener first and then the lower. The upper bolt
cannot be installed when the lower bolt is installed.
3. Walk the second stage drive belt onto the Generator/Eddy Brake assembly pulley and
larger second stage Step-up Pulley/Tensioner assembly pulley.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Generator/Eddy Brake assembly Replacement
Page 110