Precor Experience Series Service Manual page 64

c. Then use the crank to rotate the input pulley a couple of rotations to seat the
belt and remeasure the belt tension.
d. If the belt tension is not within specification, repeat the tension adjustment pro-
cess until the belt tension is correctly tensioned.
7. Use a 1/2" socket to tighten the two Drive Components assembly carriage bolts (left
side), torque bolts to 180 in-lbs +/- 54 (20.3 +/_ 4.5 Nm).
8. Measure and verify that the second-stage drive belt is within specification, retention
the belt as needed, see
page.
9. Reinstall the left Drive Disk cove, see
10. Reinstall the Drive Access Panel, see
11. Verify machine operation and return to service, see
page 19.
See Also
"Second Stage Drive Belt Tension Adjustment" on the next page
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
"Second Stage Drive Belt Tension Adjustment" on the next
" > " on
"" on page 78.
5 Adjustment Procedures
First Stage Drive Belt Tension Adjustment
page 80.
"Operation Verification" on
Page 55