Table of Contents
Advertisement
•
C534, C534i Self Powered Elliptical Fitness Crosstrainerl
Procedure 7.13 - Replacing a Ramp Assembly
Procedure.
1.
Remove the three bolts that fasten each pivot arm connector to the stairarm. See Diagram
7.6.
2.
Rotate both stairarms to the rear of the unit.
3.
Remove the screws that fasten the ramp end cap to the ramp assembly. Slide the ramp end
cap out of the ramp assembly and rotate the ramp assembly toward the rear of the unit.
4.
Remove four rear ramp mounting bolts (2 each side). See Diagram 7.9.
Diagram 7.9 - Rear Ramp Mounting
•
Ramp Bracket-
Ramp
Mounting Bolt
•
5.
Remove the two mounting bolts from the front bottom of the ramp assembly. These bolts
fasten the ramp to its front support.
Page 49
Advertisement
Table of Contents
