Precor Experience Series Service Manual page 179

4. Remove the four rear nut plate bolts and the two nut plates. Hold the ramp while
removing the last bolt and lift and slide rearward out of the display mount weldment to
remove: Retain part(s) and/or fastener(s) for installation.
Installation
1. Slide the ramp front onto the display mount weldment. Align the front bolt holes and
secure using the two mounting bolts, flat washers, and nuts. Do not fully tighten.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Ramp Replacement
Page 170