Precor Experience Series Service Manual page 163

b. Remove the 9/16" hex head cap screw and remove the Linkarm from the Stair-
arm weldment - Linkarm bracket and carefully lay onto the floor.
c. Remove the Inner Linkarm cover and Linkarm Transition cover from the Stair-
arm Linkarm mount. Retain hardware and fastener for installation.
Removing the Stairarm from the Input Drive Crank
2. Remove the Stairarm from the Input Drive Crank:
a. Remove the #2 Phillips screw and slide the Outer Pivot Block cover rearward
and away from the frame to remove. Retain part(s) and/or fastener(s) for install-
ation.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
6 Replacement Procedures
Stairarm Replacement
Page 154